The hot water boiler in the boiler is both a website product and a website keyword. Therefore, it is necessary to familiarize and understand, and to achieve a comprehensive level, in order to achieve the correct use and rational use of the product. In addition, there are good economic benefits, and at the same time, everyone can also gain some inspiration and inspiration.
How many tons of hot water boilers are 1.29MW hot water boilers?
The hot water boiler, if it is 29 MW, indicates that the rated heating capacity of the boiler is 29 MW/hr, and the conversion is equivalent to 1 ton per 0.7 Mw. 29 MW is equivalent to 40 tons, so The 29MW hot water boiler is equivalent to a 40-ton hot water boiler, but this is only an estimate.
- Is there a prescribed procedure for starting and stopping the hot water boiler?
The start and stop of a hot water boiler is a prescribed step. When the boiler is started, the first is the running circulation pump, and then the burner is ignited. When the boiler is shut down, the burner is stopped first, and the circulation pump is stopped after running for a while. However, in terms of operation mode, the traditional is manual operation. With the continuous development and advancement of technology, computer controlled operation can be realized instead of manual operation. Moreover, its operational steps can be set by the program, which also avoids erroneous operations.
- Normal pressure and vacuum and hot water boilers, which one needs to drain?
Atmospheric pressure boilers and vacuum boilers in hot water boilers, boilers need to be drained during operation. They are atmospheric pressure hot water boilers. Vacuum hot water boilers do not need to do this work because: atmospheric hot water boilers, There is systematic water entering the boiler, and the boiler is burning high temperature water. After the system hydration is treated by the soft water equipment, only most of the calcium and magnesium ions in the water can be removed, but a small amount will enter the boiler. Therefore, when the calcium and magnesium ions reach a certain concentration, a sewage operation is required to avoid problems due to the presence of these ions.
- If you know the rated working pressure of the hot water boiler, how to determine the setting pressure range of the safety valve?
The hot water boiler, if it knows its rated working pressure, can determine the setting pressure range of the safety valve. At the lower limit of the pressure value, it is 1.1 times the working pressure, but not less than the working pressure plus 0.07 MPa. At the upper limit of the pressure range, it is 1.2 times the working pressure, but not less than the working pressure plus 0.1 MPa.
