So how can we save power consumption? Your indoor height. The function of the hot water boiler ignition system is to ignite the mixture of air and fuel. The main components are: ignition transformer, ignition electrode, electric high voltage cable. A safer ignition system is called an electronic pulse igniter, which is widely used by gas boiler manufacturers such as Zhuoyi Energy Saving. It is convenient and time-saving, just press with a finger, and the safety is high, there will be no safety accident due to accidental flameout. Once the flameout state occurs, the control system can close the solenoid valve in time and shut off the gas passage. The gas hot water boiler adopts the burner down mode, the two-pass structure, the fuel combustion is sufficient, the boiler runs stably and takes up less space, and the spoiler is inserted with the spoiler to slow the exhausting speed, increase the heat exchange amount, and the boiler has high thermal efficiency. Reduce user usage costs 2. Indoor heating temperature levels. 3. The direction and number of layers in the living room. 4. Outdoor temperature 5. Whether the periphery of the bedroom is close to heating. 6. The insulation effect of the doors and windows of the room. 7. The wall insulation of this house. 8. The method used by the user, and so on.
Then the power configuration of the hot water boiler should be reasonable. Biomass boilers: horizontal biomass boilers, vertical biomass boilers. Biomass gas heat transfer oil furnace, biomass hot water boiler, biomass hot water boiler, biomass heat transfer oil furnace. Too much power configuration can’t be too small, but the power configuration is too large, but not as large as the power configuration prompt. The power configuration is too small, the hot water boiler has been trying to reach the set temperature, but it is not always able to reach the set temperature. This is because the heat that the hot water boiler fills into the room is less than the heat loss in the room. The heating rate of the room is slow and not obvious, which not only wastes electric energy, but also does not provide a comfortable heating effect. Run at low temperatures without anyone. The hot water boiler system is thermally inert and cannot be heated immediately upon opening or immediately upon shutdown. When a person is not at home, turn the temperature down instead of shutting down the system, or turn off the hot water boiler when you are not at home for a long time. Reasonable use of peak and valley electricity. Use valley electricity at night, the temperature is slightly adjusted, and even the heat storage tank can be used. When the peak power is reached during the day, the temperature will decrease. The house should be insulated. Good heat insulation can prevent overheating loss, doors and windows can not have obvious gaps, windows with double-layer central control glass, wall surface should be well insulated, energy saving effect will be very significant.
