YQW series gas-fired thermal oil boilers have a three-pass round coil structure. A conical coil is used for the effective protection of the furnace wall at the boiler end. This product is equipped with an advanced combustion device and is fully automated in operation. After the burner ignites the fuel, flame fills the round coil tubes and transfers heat by radiation through the tube wall (first pass). The high temperature flue gas gathers at the back door and then turns to the convection tubes section (second pass), where heat transfer takes place by convection. The flue gas gradually cools down here and flows to the front door, where it is reversed and goes into the third pass. After that, it enters into the chimney through the economizer and is released into the atmosphere.
This type of heater is delivered as a whole, and is installed on site, it only needs to connect thermal gas(oil) piping and electricity to start operation. The heater has four heating areas: furnace radiation heating area, the first convection tube bundle heating area, the second convection tube bundle heating area and economizer (waste heat boiler).
1. Thermal efficiency above 95%
2. Fully automatically safe operation
3. MODEL: YY(Q)W(L)
4. Fuel: Natural gas, coke oven gas, LPG, diesel, heavy oil, light oil, etc
5. Temperature: 320℃
6. CAPACITY: 0.7-29 MW (600000 kcal to 12000000 kcal)
7. Working Pressure: 0.8-1.0MPa(8 bar to 10 bar)
1. Wide fuel adaptability, compatible with burners that use a wide range of fuels including natural gas, coke oven gas, methane, 0# diesel, heavy oil, etc.
2. Save you money and time with custom designed and engineered flue gas heat recovery systems and boiler house layout plans.
3. Thermal efficiency over 5% higher than normal thermal oil boilers, annual fuel cost savings for each 7MW boiler as high as USD46,000.
4. Full atomation that enables unattended operation.
5. Safety assured by advanced oil temperature and pressure control system.
